Machine setup
Heat press power connection
Heat presses draw a lot of current while they heat up. Wire yours like this and it will heat evenly, trip safely if something goes wrong, and keep you safe.
The connection
- Main power boardYour distribution board
- 16 A MCBProtects against overload and short circuit
- 13 A wall socketA safe, stable connection
- Heat pressPlugged in with a 3-core cable
Copper wire sizes
| Connection | Wire | Notes |
|---|---|---|
| Main board → MCB | 2.5 mm² | Safe, reliable supply |
| MCB → wall socket | 2.5 mm² | Recommended size |
| Wall socket → machine | 2.5 mm² flexible | Good-quality 3-core cable |
| Earth (E) | 2.5 mm² | Mandatory for safety |
Key points
- Always use a 16 A MCB to protect against overload and short circuits.
- Use a 13 A wall socket for a safe, stable connection.
- Proper earthing is mandatory.
- Use 2.5 mm² copper wire throughout.
- Switch the power off before connecting or servicing anything.
- Make sure every connection is tight and properly insulated.
Use a qualified electrician
All wiring and installation must be done by a qualified electrician, using good-quality copper wire, certified sockets and reliable components. Cheap cords and accessories can overheat, short-circuit, start a fire or damage the machine.
Not sure your supply is right for your machine? Ask us on WhatsApp before you plug it in, or see heat press settings.