ST-3042 3D Vacuum Heat Press Spare Parts & Accessories

A 3D vacuum press uses suction to pull a silicone sheet tight around the item, so a leak or a failing pump usually shows up as patchy or faded transfers. The vacuum side of this range includes the vacuum pump, vacuum pipe, solenoid, sealing strip, silicone rubber sheet and air filter.

For heating and control there is a bottom heater, thermal sensor, thermostat and motherboard. The clamps hold mugs, cups and plates in position during pressing, and a heat-resistant glove is listed for handling items straight out of the machine.

If the press stops holding vacuum or will not reach temperature, describe the fault and send a photo of the suspect part to Print Right on WhatsApp to help identify what to replace. Mugs, plates and other items to print are in sublimation blanks.